Network management · 7 September 2026

Why flow and pressure belong together

Water demand changes through the day. Flow control valves (FCV) and pressure control points (PCP) tie zone control to demand and to reference pressure measurements.

Cutaway view of a flow control valve chamber: main, motorised valves and control panels

Demand on a network changes through the day

Not every zone of a network needs the same amount of water at the same time. Peak-use hours and low-consumption periods create different operating conditions. Assessing flow and pressure together is therefore one of the basic steps of zone control. Rather than reading a single measurement as if it explained the whole system, you look at the relationship between the two parameters.

Linking the reference point to the valve

In this approach, the FCV defines the point where flow is controlled, and the PCP defines the reference point where pressure is read. The pressure measured at the PCP is used to adjust the valves in the FCV chamber. This creates a direct link between the measurement in the field and the control applied.

Coordinating sources and time schedules

When a zone is supplied from more than one source, communication between the control points also becomes important. The system definition provides for different FCV points to operate in coordination towards a shared zone target. Source capacity, the cost of water supply and the condition of the mains are among the factors that can be taken into account when the operating schedule is drawn up.

Time schedules allow the required pressure to be set by day and by time window. The aim is an operating regime that takes conditions of use into account. How this is applied in the field is determined by measurement, engineering design and commissioning work.

Reading the example charts correctly

The daily consumption charts in the flow control system’s product document are examples that explain the current and the target way of operating; they should not be read as the measured savings of a particular plant. Each application is assessed with its own network data, and results are tracked under that network’s operating conditions.